Important Message! Please Enable Cookies in your Web Browser to Continue.
Once you have enabled cookies, please close your Web Browser and re-open.

Aquacoat Clear Wood Grain Filler Pint

Item #: AQ10000

Aquacoat Clear Wood Grain Filler Pint

$18.95

Quantity to Add:

  • Aquacoat Clear Wood Grain Filler Pint Image
 

Description



Large, open wood pores are difficult to fill with ordinary finish. Aqua Coat Clear Grain Filler leaves your project's surface smooth as glass and saves money by shortening finishing time.

Aqua Coat Clear Grain Filler is a water-based, easy-to-apply gel designed for filling and leveling the pores of "open-grain" wood structures such as oak, mahogany, and ash. It reduces the number of sealers and top coats required to obtain a glass-like, high-build finish.

Benefits:

  • Dries in 30-45 minutes for a faster build
  • Crystal clear when dry
  • Easy sanding
  • Nonflammable
  • Low odor and low VOC
  • Can be tinted with water-soluble colorants or dyes
  • Can be thinned with water
  • More OSHA-friendly than solvent-based
  • Lower insurance premiums
  • Minimal shrinkage
  • Water clean-up

Good for:

  • Furniture makers
  • Luthiers (guitar makers)
  • Gun stock finishers
  • Cabinet makers
  • Piano restoration
  • Antique restoration
  • Woodworking hobbyists

Surface preparation:
Surface must be clean and dry (free from all dirt, oil, wax, and polish). Sand surface thoroughly. Remove all dust with a vacuum, forced air, or water-dampened cloth.

Recommedations for use:
Always try product on sample board first. Aqua Coat Clear Grain Filler should be applied after the piece is stained, and/or a seal coat (Aqua Coat "X-119" Sanding Sealer) has been applied. Stain and seal coat must be dry and lightly sanded with 220-grit or finer sandpaper. Grain Filler can be tinted with water-soluble colorants or dyes. If no stain or seal coat is used, you may apply Aqua Coat Clear Grain Filler to the raw wood. Grain Filler may be applied with a soft cloth, using a circular motion, much like applying a paste wax. Or work Grain Filler generously into open wood grain pores with a small squeegee or flexible putty knife. Inspect to see if the grain is completely filled, then scrape or squeegee to remove excess. Let dry 30-45 minutes, then lightly sand with 320-grit paper. If grain is not completely filled, repeat the application process. 1-2 coats of Grain Filler are recommended. A seal coat (Aqua Coat "X-119" Sanding Sealer) and sanding between coats is also recommended. Allow overnight dry time. A final coat of finish is always recommended over the Grain Filler. Aqua Coat Clear Grain Filler may be thinned with water and dries crystal clear. Do not let product freeze.

 
CA Residents:
Prop. 65 Warning