Enduro Water-Based Conversion Varnish Flat W/ 13oz NCO Catalyst (G)

Enduro Water-Based Conversion Varnish Flat W/ 13oz NCO Catalyst (G)

Water-based Conversion Varnish is a clear drying, two-component, post-catalyzed urethane topcoat for professional use when ultimate durability is needed. Use this wood finish for high-use projects, such as bars, commercial tabletops, bathroom vanities, dishwashers, kitchen cabinets, or other high-moisture areas. Suitable for interior and exterior projects, CV is the most durable water‐based topcoat in GF’s product line and significantly outperforms solvent‐based CVs.

Requires thoroughly mixing 10 parts CV to 1 part NCO Catalyst by volume using a power mixer. Once combined, strain through a fine mesh strainer and let sit for 15 minutes before use. Pot life is about 6 hours once combined. The mixture will solidify after 6 hours.

Recommended uses: Interior or exterior cabinets, trim, doors, furniture, table tops, and bar tops. Use over raw wood, stain, and non-white painted surfaces.

Specs

• Product Colors:Water White in can (dries clear)
• Base Type:Water
• Ambering:No
• Sheen:Flat (10 or less), Satin (25-35), Semi-Gloss (50-60), Gloss (80+)
• Interior or Exterior:Interior/Exterior
• Tintable:No
• Type:Urethane/Acrylic Blend
• Coats:3 coats
• Application Method:Spray
• Brushable:No
• Usable over existing finishes:Yes
• Spray Tip Sizes:HVLP 1.1mm-1.3mm
• Dry Time - Touch:30+ min.
• Dry Time - Recoat:2+ hrs.
• Dry Time - Light Use:72 hrs.
• Dry Time - Cure:7 days
• Coverage:450 sq. ft.
• Viscosity:Medium
• Viscosity (cPs):350-450
• Durability (Highest, High, Medium, Low):Highest

Preparation

Raw Wood

1. Sand no finer than 220 grit.
2. Remove dust.

Sealed Surface

1. Scuff clean with a non-woven abrasive pad & 50:50 mix of denatured alcohol & water.
2. Dry 1-2 hours.
3. Sand lightly with 220-320-grit sanding sponge.
4. Remove dust.

Download Technical Data Sheet

Download Safety Data Sheet

Download Catalyst Safety Data Sheet